Page 1 of 1 Pages: 1
Results 1 - 20 of 20
Do an internet search for Crower Clutches (notice correct spelling of Crower, no L)
by
diesel greaser
-
Forum
Am running 18.4s on a 20" rim, had to play with tire pressure to get a cupped spin out foot print vs a humped spin out foot print.
by
diesel greaser
-
Forum
Indiana Pulling League Hot Farm Class 'Always Something' is a V-8 Massey. Search on YouTube for Indiana Pulling League. This tractor was not out much in 2020 and not at all 2021.
by
diesel greaser
-
Forum
Another way is to check with an ADS station, they may be able to machine the front bearing plate of the 'P' pump to fit the 'A' pump hole so the hole in the block doesn't have to be machined. You will need to drill and tap new holes for the 'P' pump mounting and will have to use a P pump gear. I know Columbus Diesel Supply used to do this kind of work, did this
by
diesel greaser
-
Forum
Idaville IN 2017 spring truck and tractor pull
by
diesel greaser
-
Forum
by
diesel greaser
-
Forum
The schedule is on the IPL website
by
diesel greaser
-
Forum
by
diesel greaser
-
Forum
video:
by
diesel greaser
-
Forum
A complete 3020 diesel engine will bolt in. Have to change throttle linkage, air intake from air cleaner, add a fuel return line to the tank and get a 12 volt diesel starter. These are the major items I can think of.
by
diesel greaser
-
Forum
Indiana Pulling League altered farm class
by
diesel greaser
-
Forum
Fleece Performance Pull 2014 9500 open tractors
Fleece Performance Pull 2014 11000 open tractors
by
diesel greaser
-
Forum
trusting you have the external oil cooler (not the one in the block water jacket): oil flows from the pump through the filter (with a bypass valve in the pump), from the filter through the cooler (with a bypass valve in the base), out of the cooler in to the main oil galley of the block through the external pipe. oil pressure regulating valve is in the block main oil galley. figure out what block
by
diesel greaser
-
Forum
hydraulic oil cooler or engine oil cooler?
by
diesel greaser
-
Forum
I covered the stock brake piston o-ring in DOT brake fluid for 4 days and let it soak, the o-ring did not swell or get softer so I didn't try to find different o-rings,
that was 2 years ago with no problems. Try soaking an o-ring yourself, it will either be ok or all you loose is an o-ring and some brake fluid.
by
diesel greaser
-
Forum
Asking for thoughts and/or experience on optimum rim width for this size tire, tractor weighing from 8000lb to 10000lb. Would it make a difference if tires are cut or uncut on rim width?
by
diesel greaser
-
Forum
It is quite easy to get the trans pump suction tube gasket installed wrong. This blocks the inlet at the trans pump by about 50% and causes loss of hydraulics quickly when the clutch is disengaged. If you are running an open center gear type hyd pump, this pump flows oil all the time it is running. If this is the type hyd pump you have, the trans pump would need to run all the time which it can n
by
diesel greaser
-
Forum
FAAS system, not inexpensive (<$1000.00) but can work well
by
diesel greaser
-
Forum
HP - is there a way I can contact you about making gears?
by
diesel greaser
-
Forum
You need a different leaf spring or your pump does not have 370 plungers
by
diesel greaser
-
Forum